Not sure what you need? Call us! 281-547-0330

Holster Making Foam

How to Recover Your HD Foam

by HD Industrial Design July 26, 2016

How to reset your foam:

The HD foam can be reset. Put in the oven at 180°F for 20 minutes - air cool. The foam should recover about 90% of its original shape. You should also be able to go back and press over the HD foam again without resetting the foam. The foam should form to whatever you are pressing each time with leaving impressions from the previous press.

HD Industrial Design
HD Industrial Design


Also in Vacuum Forming Tips & Tricks

Troubleshooting Leaks Tips & Tricks
Troubleshooting Leaks Tips & Tricks

by Jennifer Oden June 28, 2018

In the unlikely event that your HD vacuum press is not holding vacuum, we go over common leak causes and solutions to get your press back up and running like it should!

Read More

Heatsink Tips & Tricks - Purpose & Usage
Heatsink Tips & Tricks - Purpose Of Heat Sink - Function Of Heat Sink - Usage Tips

by Jennifer Oden June 20, 2018

How do I properly prepare the heatsink for my molds? Let's discuss the best options for getting your heatsink setup and optimized for your vacuum forming needs.

Read More

Membrane Tips & Tricks - Optimizing Membrane
Membrane Tips & Tricks - Cleaning Vacuum Former Membrane - Reduce static

by Jennifer Oden June 13, 2018

What is the best way to get rid of static buildup and optimize your vacuum forming membrane for the best vacuum seal possible? Lets go over some easy ways clean it and reduce static!

Read More