Not sure what you need? Call us! 281-547-0330

Easy to use Vacuum Forming Machines. Get the right Vacuum Former Tool.

Automated Vacuum Forming - Best of the Best

The HD Automated Vacuum Control System

by HD Industrial Design August 12, 2014

The HD Automated Vacuum Control System is designed to work with the HD Vacuum Press series. This controller monitors & maintains vacuum on any vacuum press.


The AVCS has integrated plumbing to act as a vacuum accumulator. This gives it enough volume to run multiple presses at once.

It is ready to go, out of the box. With its plug & play design no assembly is required. Secured to a sheet of acrylic, it is mounted in any position.

It is powerful enough to operate multiple presses at the same time. The HD AVCS is what streamlined vacuum press operations have been waiting for.


Monitors and maintains vacuum on the HD Press and other vacuum presses.
27 1/2 - 23 InHg - Adjustable
Plug & Play design
Ports 1/2" threaded - for Press, Pump, and Aux.
Aux port for optional accessories - vacuum gauge, accumulator tank, etc.
Works with any 110 Volt vacuum pump
Mounts in any position
No assembly required
Can be used to control the level of vacuum on any vacuum press
Integrated plumbing acts as vacuum accumulator
Has enough volume to run multiple presses at once
90 Day Warranty

Pump Check Valve
Vacuum Filter
Heavy Duty Vacuum Switch
Heavy Duty Power Cord

You will need to acquire a vacuum pump to run this system. We recommend the following two pumps - based on what you will be pressing you will have to decide which will work best for you:

Robinair 15800 VacuMaster 8-CFM Two-Stage Vacuum Pump

Robinair 15310 VacuMaster 3 CFM Single Stage Pump

Be sure to check out the Automated Vacuum Control System now available -


HD Industrial Design
HD Industrial Design


Also in Vacuum Forming Tips & Tricks

Troubleshooting Leaks Tips & Tricks
Troubleshooting Leaks Tips & Tricks

by Jennifer Oden June 28, 2018

In the unlikely event that your HD vacuum press is not holding vacuum, we go over common leak causes and solutions to get your press back up and running like it should!

Read More

Heatsink Tips & Tricks - Purpose & Usage
Heatsink Tips & Tricks - Purpose & Usage

by Jennifer Oden June 20, 2018

How do I properly prepare the heatsink for my molds? Lets discuss the best options for getting your heatsink setup and optimized for your vacuum forming needs.

Read More

Membrane Tips & Tricks - Optimizing Membrane
Membrane Tips & Tricks - Optimizing Membrane

by Jennifer Oden June 13, 2018

What is the best way to get rid of static buildup and optimize your vacuum forming membrane for the best vacuum seal possible? Lets go over some easy ways clean and reduce static!

Read More