HD 2424 Vacuum Former - Pro Kit

HD-2424-PRO

2 reviews

Are you looking for a professional setup to start vacuum forming your products? Don’t know what you should get to streamline production?

This is the solution you need. With this vacuum former kit you’ll have everything necessary for your vacuum former setup. Now you can have the right tools to save time, money and make the best quality products possible.

Instructions

Download Instruction Manual

Customer Reviews
5.0 Based on 2 Reviews
Write a Review

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
RR
08/26/2020
Ronald R.
United States United States
HD 2424 Review

I purchased this intent on making a product and found that my design wasn't conducive to vacuum forming, however; I have some other ideas to utilize it . I "played" with it to become familiar and it seems to work great with no problems. It was packed and shipped with great care and it shows in the condition when I unpacked it. Seems to be a quality machine.

TC
03/30/2020
Tyler C.
United States United States
Top of the line equipment.

I’ve only used it twice so far, but this thing is Amazing. Easy to set up and is ready to use within 10 minutes of unboxing. Very happy with my purchase.

Q: I am looking for a vacuum former to make scale airplanes models, would this machine work for me? How does this machine heat up the material to be formed?

A: Our vacuum presses do not have built in heaters. You have to heat your material externally and then transfer it to the press to be molded. There are many different ways to heat materials depending on the type and thickness. Heat press, flash dryer, oven, toaster oven, etc.

Q: My HD Press won't hold vacuum when I close the valve. How can I troubleshoot and fix this?

A: Check the membrane for dirt and clean it with a damp sponge. A dirty membrane can effect the seal. Check for holes in your silicone membrane. If you have formed anything with sharp edges that were not properly covered the silicone membrane can be punctured. Take the heat sink off the press, wet your thumb and place it over the port and pull a vacuum. This will narrow down where the leak is. If the vacuum holds with your thumb over the port, then you can rule out the plumbing. If it doesn't, then the leak will be somewhere between the port and your pump. Check all the plumbing connections to make sure they are securely seating in the fitting. If you can't find the source after this, please contact us for help.

 

Q: How much vacuum is required to form kydex? 

A: Most of the time all you will need for Kydex to form for knife shealths and gun holsters is around 27inHG.

 

Q: Will this work for leather holster forming?

A: Yes. Many of our users are doing leather holster forming with the HD Press.

Vacuum Former Machine Professional Kit

FEATURES

•  Plug and play ready to go out of the box

•  Pre-Converted Vacuum Pump

•  Extra Membrane

•  Extra Tubing

•  19.125” x 19.125” work area

•  Quick change membrane

•  Customizable heat sink

•  Maintenance free

•  Rugged design

•  Gasket free

•  Made in the USA

INCLUDES

•   HD Press 2424

•   5 CFM Two-Stage Vacuum Pump with check valve

•   2 Extra - High Temp Heavy Duty Membranes

•   Neodymium Magnets (+ 5 extras)

•   Heatsink board 

•   Premium Quality Liquid Filled Vacuum Gauge

•   ON-OFF Valve

•   Vacuum Release Vent

•   1/2” Easy Connect NPT Elbow

•   3/8” Easy Connect NPT Elbow

•   2 - 1/2" Easy Connect Elbows

•   6ft Extra Tubing

5 CFM Vacuum Pump Kit