No Longer Available
Are you searching for an easy way to start vacuum forming? Not sure what stuff you should buy to get setup? Looking for the easy button? You’ve found it!
Get started with vacuum forming quickly with this kit. Right out of the box all the needed tools are included ready to go. You can be vacuum forming in minutes without all the headaches! Stop searching and start making high quality products. With this kit you will save time, money and reach your goals!
Q: I am looking for a vacuum former to make scale airplanes models, would this machine work for me? How does this machine heat up the material to be formed?
A: Our vacuum presses do not have built in heaters. You have to heat your material externally and then transfer it to the press to be molded. There are many different ways to heat materials depending on the type and thickness. Heat press, flash dryer, oven, toaster oven, etc.
Q: My HD Press won't hold vacuum when I close the valve. How can I troubleshoot and fix this?
A: Check the membrane for dirt and clean it with a damp sponge. A dirty membrane can effect the seal. Check for holes in your silicone membrane. If you have formed anything with sharp edges that were not properly covered the silicone membrane can be punctured. Take the heat sink off the press, wet your thumb and place it over the port and pull a vacuum. This will narrow down where the leak is. If the vacuum holds with your thumb over the port, then you can rule out the plumbing. If it doesn't, then the leak will be somewhere between the port and your pump. Check all the plumbing connections to make sure they are securely seating in the fitting. If you can't find the source after this, please contact us for help.
Q: How much vacuum is required to form kydex?
A: Most of the time all you will need for Kydex to form for knife shealths and gun holsters is around 27inHG.
Q: Will this work for leather holster forming?
A: Yes. Many of our users are doing leather holster forming with the HD Press.
Excellent fit for larger molds. Work area - 19.125” x 31.125”
• Plug and play
• Ready to go out of the box
• Pre-Converted Vacuum Pump
• Extra Membrane
• Extra Tubing
• 19.125” x 31.125” work area
• Quick change membrane
• Customizable heat sink
• Maintenance free
• Rugged design
• Gasket free
• Made in the USA
• 1 Extra - High Temp Heavy Duty Membrane
• Neodymium Magnets (+ 5 extras)
• Heatsink board
• Premium Quality Liquid Filled Vacuum Gauge
• ON-OFF Valve
• Vacuum Release Vent
• 1/2” Easy Connect NPT Elbow
• 3/8” Easy Connect NPT Elbow
• 3ft Extra Tubing
Industries used in - dental, aerospace, special effects, military, Holster Making, Knife Sheath Forming, Hobbyists, Cosplay, Costume Makers, Orthotics, small prototyping and many other types of thermoforming.
Different materials thermoformed on the HD Press -Kydex, Boltaron, ABS, HIPS, PETG, Wonderflex, Worbla, Styrene, Cork, Leather, Plastics,and other types of thermoformed & vacuum formed materials.BUY NOW